Roll shaped sand making machine

　　产品简介

　　Product Introduction

　　The WXZ series roller shaped sand making machine, as the first and leading industry product of our company, has been successfully developed by the founder Mr. Wu Yuanzhong after decades of work, thousands of on-site inspections and debugging, and comparison with nearly 20 market products. It has the advantages of low energy consumption, high efficiency, large particle size ratio to crushing, uniform product particle size, simple and easy maintenance structure, and is a high-quality, high-efficiency, and cost-effective machine that can meet the crushing of ores and rocks of various hardness by rollers. It has received a lot of praise and repurchase from customers since its launch.

　　Performance characteristics

　　1. Round particle size and reasonable grading

　　By using extrusion instead of impact and impact to crush, the reasonable speed, flow rate, and pressure can be adjusted to generate strong biting friction between materials, achieving a strong shaping effect.

　　2. Low consumption

　　Single motor frequency conversion drives direct extrusion between rollers, with high molding rate and controllable powder content, thus achieving low energy consumption.

　　3. Easy to maintain and low production cost.

　　The roller speed is relatively low, and the material is squeezed between the two rollers, which can significantly reduce the loss between the rollers. Due to low-speed rotation, the general lifespan of motors and reducers is 3-5 years, and apart from the wear and tear of the rollers themselves, other components have almost zero wear and tear.

　　4. Structural standardization

　　Based on the power of the motor and extensive practical experience, each model of roller matching machine has stable data on the size of the gearbox, roller size, bearing model, and transmission ratio, achieving standardized production. Except for the loss, other components have basically zero loss.

　　Explanation of parameter table:

　　1. The maximum feed particle size (raw material size) is the relative size of the actual feed, which is approximately 85% to 90% of the machine feed size (design measurement value).

　　2. Adjust the extension length of the motor push rod and the size of the baffle opening according to the size and granularity of the discharge volume to control the uniformity of the feed volume. Reasonably adjust the size of the feed inlet to improve production capacity.

　　3. The discharge port at the bottom of the hopper should be kept unobstructed. To prevent material blockage in the hopper, which affects the normal operation of the rolling mill and leads to a decrease in production.